Demo · sources listed
Where the Streets Have No Name — dotted-eighth intro riff
U2 · Where the Streets Have No Name · Chiming AC30, cascading stereo echoes
Checked · 6 blocks · 41 settings
The catalog matches CorOS 4.1.1, compiled October 2026. On older firmware, a block can be missing.
The chain, in signal order
- Exotic Z Boost (Overdrive, row 1, slot 1)
GAIN 2, BASS 5, TREBLE 5.5, VOLUME 6
This boost isn't on the record. It pushes the AC30 slightly harder for the full-band 16th-note strumming, standing in for Edge digging in, and stays bypassed for the intro.
- UK C30 TopBoost (Amp, row 1, slot 2)
VOLUME 4.5, BASS 4, TREBLE 6.5, TONE CUT 3.5, BOOST COOL, OUTPUT 0 dB
The AC30 Top Boost was Edge's main amp of the era. Set just under breakup, it keeps the chime and pick attack clear through the repeats.
- 212 UK C30 ’65 (Cab, row 1, slot 3)
MIC Dynamic 57, POSITION 3.5, DISTANCE 1.5, HPF 80 Hz, LPF 9000 Hz
A 2x12 AC30 cab with 60s Celestion alnicos. A 57-style dynamic mic slightly off the cap keeps the top end sparkling without harshness.
- Digital Delay (M) (Delay, row 1, slot 4)
SYNC Off, DELAY TIME 352 ms, FEEDBACK 22%, MIX 40%, HIGH PASS 100 Hz, LOW PASS 7000 Hz, MOD RATE 0.5 Hz, MOD DEPTH 12%, DYN MODE Off, TRAILS On
The main dotted-eighth delay stands in for the SDD-3000. It's a clean, lightly modulated repeat with 1-2 repeats at roughly 70% of the dry level, which is Darling's 'about 70%' delay mix, and the Mixer pans it mostly right.
- Digital Delay (M) (Delay, row 2, slot 4)
SYNC Off, DELAY TIME 523 ms, FEEDBACK 0%, MIX 33%, HIGH PASS 100 Hz, LOW PASS 6000 Hz, MOD RATE 0.4 Hz, MOD DEPTH 10%, DYN MODE Off, TRAILS On
The second delay sits on parallel Row 2. It gives exactly one repeat at 1.5x the first delay (9/32), at about half the dry level, and the Mixer pans it mostly left. It fills the gaps between the dotted-eighth repeats, as in Darling's two-amp split.
- Room (Reverb, row 1, slot 5)
DECAY 1.2 s, PRE DELAY 15 ms, HIGH PASS 150 Hz, LOW PASS 6000 Hz, MIX 15%, TRAILS On
A short, dark room after the Mixer gives both delay paths a shared space, without washing out the rhythm the delays create.
Scenes
- Scene A · Intro Riff Both delays are on, with 352 ms mostly right and 523 ms (one repeat) mostly left. The boost is off and the Room is at 15%. Use this for the cascading intro and outro arpeggio. Bypassed: Exotic Z Boost.
- Scene B · Chorus Push The boost is on to drive the AC30 harder. Both delays drop a little in the mix and the Room rises, so the heavier 16th-note strumming stays defined. Changes: Digital Delay (M) (row 1, slot 4) MIX 35%; Digital Delay (M) (row 2, slot 4) MIX 28%; Room MIX 18%.
- Scene C · Single Dotted 8th Both delays play the same dotted eighth: Delay 2 takes Delay 1's time, and both get more feedback. The classic single dotted eighth (2-3 repeats) then sits centred in stereo and in mono. Use it for small rooms, practice or covers of other dotted-eighth parts. Changes: Digital Delay (M) (row 1, slot 4) FEEDBACK 30%; Digital Delay (M) (row 2, slot 4) DELAY TIME 352 ms, FEEDBACK 30%, MIX 40%. Bypassed: Exotic Z Boost.
- Scene D · Dry Check Both delays are bypassed, so you hear only your picking hand. Use it to lock your eighth notes to a click before bringing the delays back. Bypassed: Exotic Z Boost, Digital Delay (M), Digital Delay (M).
Rig story
- Original rig
- The track was recorded at Windmill Lane in 1986, produced by Eno and Lanois. The part is a Stratocaster through Korg SDD-3000 delay. On the album Tim Darling measures repeats at about 350 ms and 531 ms, and he models the part as two modulated delays: 352 ms with 1-2 repeats panned mostly right, and 523 ms with one repeat panned mostly left. Each feeds its own amp, and both amps carry the dry signal. Nobody has firmly documented the studio amp for this song. Edge's vintage Vox AC30s were his main amps of the era, so this recipe uses one. Some sources claim the song was cut through 1950s tweed Fender Deluxes, citing Mark Howard's Tape Op #134 interview. In that interview, though, the 'SDD-3000 into tweed Deluxes' passage is about Neil Young's Le Noise sessions, not The Edge.
- Instrument
- Fender Stratocaster (maple neck), bridge pickup, standard tuning (the album is in D; the Rattle and Hum live take is tuned down a half step)
- Routing
- Rows 1-2, with one Splitter and one Mixer. 1. Row 1: In 1 > Exotic Z Boost (slot 1) > UK C30 TopBoost (slot 2) > 212 UK C30 ’65 cab (slot 3). 2. Splitter between slots 3 and 4: TYPE Balance, BALANCE centre, STEREO Off. 3. Path A stays on Row 1 and goes to the 352 ms Digital Delay (slot 4). 4. Path B drops to Row 2 and goes to the 523 ms Digital Delay (Row 2, slot 4). 5. Mixer between slots 4 and 5: LEVEL A -3 dB, PAN A R70, LEVEL B -3 dB, PAN B L70, PHASE Off. 6. After the Mixer: Room (Row 1, slot 5) > Multi Out. Both paths carry the dry signal plus their own delay. The dry sums to centre while the 352 ms repeats sit mostly right and the 523 ms repeats sit mostly left, as in Darling's two-delay, two-amp diagram. The split comes after a single amp and cab to save CPU.
Tips
- Pick the intro arpeggio as steady, even eighth notes. The dotted-eighth repeats fall between your notes and make the 16th-note shimmer. Darling also suggests hitting the high-E string a little harder so it and its echoes stand out.
- Tempo: Wikipedia gives 126 BPM. Darling gives 129 BPM, calls the delays 3/16 and 9/32 of a bar, and measures about 350 ms and 531 ms on the album itself. To play along with the record, keep the ms values; 350/531 is a close alternative. With a band, set Delay 1 to 0.75 x (60000 / BPM), which is 357 ms at 126 BPM. Set Delay 2 to 1.5 x Delay 1, which is 536 ms at 126 BPM. You can turn on SYNC with 1/8D on Delay 1 to use tap tempo, but Delay 2 has no 9/32 sync note, so set it in ms by hand.
- Scene changes only stick if you scene-assign each parameter first. Long-press Delay 2's DELAY TIME, FEEDBACK and MIX, Delay 1's FEEDBACK and MIX, and the Room MIX, then set each scene's values.
- Keep feedback low. The record has only 1-2 repeats on the main delay and a single repeat on the second, and more feedback smears the rhythmic interlock.
- If the delays feel too loud in stereo, lower both delay MIX values a few percent together rather than raising feedback. The dry signal from both paths sums in the centre, so small changes go a long way.
- For full two-amp fidelity, move the Splitter to just after the boost. Then run delay > UK C30 TopBoost > cab on each row, matching Darling's delay-before-amp diagram. Check the CPU meter, because a second amp and cab roughly doubles the load.
Sources
- https://www.amnesta.net/edge_delay/streets.html
- https://www.amnesta.net/edge_delay/
- https://en.wikipedia.org/wiki/Where_the_Streets_Have_No_Name
- https://articles.boss.info/patch-work-where-the-streets-have-no-name-by-u2/
- https://tapeop.com/interviews/134/mark-howard
- http://www.baselines.com/wp-content/uploads/all-songs/Documents/Tape_Op_134.pdf
- https://neuraldsp.com/manual/quad-cortex
- https://unity.neuraldsp.com/t/solved-change-splitter-settings-on-different-scenes/21668
This is a starting point. Your guitar, pickups and headphones or speakers change the sound, so adjust by ear from here.
© 2026 Gridtone, made by Loïc Sans, loicsans.me. QC-style grid. Gridtone is independent and not affiliated with Neural DSP or Anthropic.